Glo-Protect High Built Acrylic PU Finish
Glo-Protek High Built Acrylic PU Finish is a two pack Polyurethane Finish Coating based on Acrylic Aliphatic Isocyanate Adduct
Suggested USES
An ideal coating to be used as a topcoat over an epoxy base coat or in a total polyurethane painting scheme. The cured film provides hard, flexible, abrasion resistant coating which has excellent weatherability, gloss and colour retention and is resistant to humidity, saline and a variety of chemically polluted environment.
TECHNICAL DATA
Colour | As required |
---|---|
Finish | Glossy |
Volume solids | 56% ± 2 |
Mixing Ratio | Base : Adduct 4 : 1 |
Pot Life | Minimum 2 hours (Depending on Ambient temperature) |
Recommended DFT/Coat | 70-80 μ |
Theoretical Covering | 11.5 M2 at 40μ |
Method of Application | Brush / Roller for small area, Conventional/ Airless spray for bigger areas |
Heat Resistance | Upto 120ºC dry heat (Intermittently) |
Thinner Recommended | Glo-Protek PU Thinner. |
Airless Spray | Tip size: 0.015"- 0.019" Fluid pressure: 2000- 2500 psi |
Drying Time | Surface Dry : 1 hour Hard Dry : 8 to 12 hours Full Cure : 7 days |
Overcoating Interval | 18-24 hours Minimum 5 days Maximum |
Overcoating Interval | 18-24 hours Minimum 5 days Maximum |
Overcoating Interval | 18-24 hours Minimum 5 days Maximum |
Shelf Life
9 months in sealed container stored at room temperature
Packing
20 litres
Precautions
Avoid inhalation. Take necessary precautions to avoid contact with skin or eyes. Ventilate the area
HEALTH & SAFETY
Use rubber hand gloves and safety goggles while handling this material. Normal PPE can be used. As a general rule, avoid inhalation of solvent vapour or paint mist and contact of paint with skin and eyes. Provide forced ventilation when working with solvent born coating in confined spaces or stagnant. Skin and eye protection follow the local and national regulations.