Glo-Protek HB Tank Lining Coating

Glo-Protek HB Tank Lining Coating is a two pack high build epoxy polyamine adduct cured tank lining paint system. This product is self priming epoxy coating designed to use tank lining for the storage of fresh & salt water, brine, sweet & sour crude, other refined petroleum products & solvents It has excellent resistance against highly corrosive & humid atmosphere


Colour White, Grey ( Dark and Light)
Finish Matt to Eggshell
Volume Solids 62 ± 3 %
DFT / Coat 75-150 μ
Theoretical Coverage / Coat 4.3 – 8.6 m² / ltr.
Type Two Pack
Mixing Ratio By Volume
Component A 4 parts
Component B 1 parts
Induction Time 0 – 40 Mins
Pot life 2 – 3 hrs at 30°C
Curing Mechanism Solvent release and chemical reaction between two components.
Flash point Component A : Above 25°C
Component B : Above 25°C
Drying Time (30°C) Surface Dry - 2 – 3 Hrs
Hard Dry - 16 – 18 Hrs
Full Cure - 7 Days
Recoating Time Min : 18 hrs
Max. : 5 days provided surface is dry, clean & free from any contaminants. After max. over coating interval the the surface should be roughened prior to the application f subsequent coat.
Cure for immersion 7 days
Thinner Epoxy Thinner
Thinner Consumption Conventional spray 20 - 40% & Brush 10 - 15%

Details of Application

Applied over : Blasted cleaned steel
Application Method : Brush / Conventional spray / Airless spray.
Shelf Life : 12 months under normal storage conditions in original containers at 30°C
Pack Size : 20 ltrs.

Surface Preparation

Before applying the piant, all surfaces must be clean, dry and free from oil, grease and other contaminants.. Blast cleaning to Sa 2.5 of Swedish International Standard . In case of aged Epoxy Primer , the surface Should be sufficiently roughened prior to painting.

Application Instruction

Stir the comp. A and comp. B separately. If settling is observed in the comp. A, loosen the settled material and mix it with the help of pneumatic stirrer. Mix the comp. B gradually to the comp. A in the specified ratio under continuous stirring till homogeneous. Use epoxy thinner as specified.

Environmental Condition

Surface temperature must be 3°C above the dew point to prevent condensation.


Air 5 - 40°C
Surface 5 - 50°C
Relative Humidity 5 – 80%

Special Notes

Thinner consumption may vary depending upon site conditions. Practical covering capacity depends on application techniques, ambient conditions, wastage, surface condition etc.

Health & Safety

As a general rule, avoid inhalation of solvent vapour or paint mist and contact of paint with skin and eyes. Provide forced ventilation when working with solvent born coating in confined spaces or stagnant. Skin and eye protection follow the local and national regulations.