Glo-Protek HB Coal Tar Epoxy Black M-122
Glo-Protek HB Coal Tar Epoxy Black M-122 is a Two Pack High Build Polyamine cured Coal Tar Epoxy Coating providing excellent adhesion, toughness, resistance to water, chemicals, chemically polluted water, crude oil, etc. but not resistant aliphatic / aromatic solvents.
Suggested Uses
Glo-Protek HB Coal Tar Epoxy Black-M-122 is ideal for long-term protection of steel on the underwater hull exterior in conjunction with cathodic protection owing to its excellent acid / alkali resistance. It is also suitable for application in the cargo holds of bulk carriers, interiors ballast tanks, Ext. Hull underwater, etc. Apply only over an Epoxy Primer.
Technical Data
Colour | Black/Brown |
---|---|
Finish / Sheen | Egg-Shell to Semi-glossy |
Flash Point | > 25ºC |
Mixing Ratio | Base : Adduct – 3 : 1 by volume |
Pot Life | 1 – 2 hrs |
Volume Solids | 63% ±2 |
Recommended DFT | 75 to 100µ |
Covering Capacity | 6.3 M²/ltr. at 100µ |
With 30% Loss | 4.4 M² @ 100 µ |
Method of Application | Brush/Roller/Con./Airless Spray. |
Airless Spray | Tip size: 0.018"-0.021" Fluid Pressure : 2000-3000 psi. |
Drying Time | Surface Dry : 1-2 hours Hard Dry : 24 hours |
Full Cure | 7 days |
Intercoat Interval | Minimum 12 hours, Maximum 5 days (for best results overcoat within 48 hours) |
Thinner Recommended | Not for Thinning / Epoxy Thinner for cleaning of equipment |
Surface Preparation
Degrease and blast Clean to Sa 2½ suitably primed
Shelf Life
12 months from the date of manufacture
Precaution
Ventilate confined spaces adequately prior to and during application to avoid suffocation.