Glo-Protek CS-1000 Cleaner
Biodegradable Concrete Cleaner
Glo-Protek CS-1000 Cleaner is an environmentally safe fluid cleaner that removes dirt, rust, tire
marks, and stains from concrete, masonry, brick, paver stones and tile. Ideal for restoring the
new looking finish to industrial, commercial and residential cement surfaces as it creates a
whitening effect on the surface.
Glo-Protek CS-1000 Cleaner is safe to use near grass and plants.
TYPICAL USES :
- Pool Decks
- Garage Floors
- Warehouse Floors
- Commercial Buildings
- Factory Concrete Floors
An effective stain remover, that is non-flammable, biodegradable, non toxic, non-carcinogenic and water soluble. It will not harm treated cement surfaces, plants or animals.
Color Light Yellow
|Vapor Pressure||(mm Hg) Greater|
|Solubility in Water||Completely|
|Boiling Point||100°C/212°F Using test tube method|
|Freezing Point||32°F (Liquid only)|
|Specific Gravity||(H20 1) 1.0 - 1.2 AT 24°C|
|Evaporation Rate||Water = Less than 1 - water|
|Weight||10.00 ± .02|
|% Solids||8% ± .02|
|Viscosity||More than water|
Method : Brush, Roll, or Spray
Theoretical Coverage : 100 square feet per Ltr
INSTRUCTIONS FOR MULTI-PURPOSE CLEANING
Dilute Glo-Protek CS-1000 Cleaner according to instructions listed below.
- Apply with a spray bottle, brush, rag, or mop.
- Allow 3 to 5 minutes dwell time.
- Scrub as needed.
- Wipe or rinse thoroughly.
- Repeat all steps if necessary.
- Mix 1 ltr Glo-Protek CS-1000 Cleaner with 1 ltr water.
SHIPPING & STORAGE
Container Type : 5 ltr * 20 ltr jar
Average Shelf Life : 12 months minimum from date of manufacture when maintained in protected storage. Storage at 15-35 degrees C.
HEALTH & SAFETY
As a general rule, avoid inhalation of solvent vapour or paint mist and contact of paint with skin and eyes. Provide forced ventilation when working with solvent born coating in confined spaces or stagnant air. Skin and eye protection follow the local and national regulations.