Glo-Protek Hs Anti-Corrosive Epoxy Coating MP-I

Glo-Protek High Solids Anti-Corrosive Epoxy Coating MP-I is a two component Polyamide cured High Solids Anticorrosive Epoxy coating applied by Stiff Bristle Brush / Airless Spray suitable for application on thoroughly prepared concrete and steel surfaces to provide an absolutely impervious finish. These coating cures to form a very tough wear resistant coating to withstand seawater, heat, fresh water, various solvents, chemicals, fats, dilute acids and almost all environmental conditions.

Suggested Uses

Most ideal coating for use in solvent/fuel storage tanks both concrete and steel, battery pits/compartments in ships, submarines and off-shore/on-shore oil installations, Duct power plant etc. Also use in battery pits/compartments, various types of fuel, chemical, solvent storage tanks, ballast, fresh water, distilled water tanks, ETP tanks, etc

Technical Data

Colour White / Pink / Gray Pastel colours
Finish / Sheen Semi – glossy
Flash Point > 25ºC
Volume Solids 85% approx.
Heat Resistance Upto 250ºC dry heat (Intermittently)
Pot Life Min. 2 hours
Recommended DFT 150 + 25 µ / coat.
Theoretical Covering 5.6 M² / Ltr./Coat at 150 µ
Mode of Application Stiff Brush/ Airless Spray
Airless Spray Tip Size : 0.021” – 0.025”
Fluid Pressure : 3000-3500 psi.
Thinner Recommended None for application. Use Glo-Protek Epoxy Thinner for cleaning of brushes, and spray equipment, etc.
Drying Time Surface Dry : Max. 5 hours @ 30º C
Hard Dry : Max. 16 hours @ 30º C
Full Cure Min. 7 days
Overcoating Interval Min. 24 hours

Surface Preparation

Degrease and blast clean to Sa 2½ min

Shelf Life

6 months in sealed containers at room temperature.

Packing

20 litres