Glo-Protek Epoxy Finish Coat 512
Two-component, Polyamide Adduct Cured, General-purpose, Air-drying Epoxy
Glo-Protek Epoxy Finish Coat 512 is a two-component, polyamide adduct cured, generalpurpose, air-drying epoxy coat. It is an excellent epoxy coat for steel exposed to atmospheric marineandgeneral conditions andhas goodresistancetomildchemicals andwater.However, likeall epoxies, it has tendencytochalk onweatheringover a periodof time.
LIMITATIONS :
Not recommended for immersion in acids, alkalies and solvents
TECHNICAL DATA :
Colour | Range |
---|---|
Finish | Semi-glossy or matt finish as required |
Volume Solids | Approx. 38% |
Mixing ratio | 3 : 1 by volume |
Pot Life | 4 - 6 hours (30ºC) |
Recommended DFT/COAT | 25 - 35 microns |
Theoretical Spreading Rate | 15.20 - 10.85 m /l at above DFT |
Surface Dry | 1 - 1.5 hours at 30ºC |
Hard Dry | 16 hours |
Fully cured | 7 days at 30ºC |
Overcoating Interval | Minimum 16 Hours & Maximum 7 Days |
Flash point | Above 28ºC |
Thinner | Epoxy thinner |
Storage | Store in sealed containers under |
Surface Preparation
The substrate surface/previous coat should be dry and free fromall surface contaminations. The indicated maximum recoating interval refers to over-coating.
Method of Application
By Air Spray, Airless Spray, Brush
Safety Information
As a general safety precaution, care should be taken to avoid contact of liquid paint with skin and eyes, and inhalation of solvent vapors or paint mist should be avoided. Air movement should be ensured with.